TO VIEW THE BMW SEAT OCCUPANCY SENSOR EMULATOR CLICK HERE

Warning: You cannot carry babies in car seats in the front passenger seat because in the event of an accident the airbag will always deploy, and cannot be deactivated. This is a temporary solution; we always recommend replacing defective components with those approved by the vehicle manufacturer.

Instructions:

1. Remove the key from the ignition.
2. Locate the seat occupancy sensor connector and disconnect it. (Under the front passenger seat, at the rear.)
3. Connect our emulator.
4. Start the car.

In a few cases, the airbag fault remains stored in the control unit and needs to be cleared with a diagnostic tool (this usually happens if you have driven for a long time with the fault light on).

BYPASS THE BMW SEAT OCCUPANCY SENSOR FAULT

Instructions to bypass the passenger seat belt fault:

1. Remove the key from the ignition.
2. Locate the yellow connector (under the front passenger seat). The shape of the connector may vary depending on the vehicle's year, but the color is always yellow.
3. Find the red and black wires in the connector; they are always next to each other.
4. Using a flat-head screwdriver, disconnect the original red wire and connect the red pin of the emulator.
5. Using a flat-head screwdriver, disconnect the original black wire and connect the black pin of the emulator.
6. Leave the original wires disconnected.
7. Start the car.

BMW SEAT BELT SENSOR EMULATOR