TO VIEW THE BMW 1 SERIES SEAT OCCUPANCY SENSOR EMULATOR CLICK HERE

Warning: Do not carry babies in child seats in the front passenger seat, because in the event of an accident the airbag will always deploy and cannot be deactivated. This is a temporary solution; we always recommend replacing defective components with manufacturer-approved vehicle parts.

Instructions:

1. Remove the key from the ignition.
2. Locate and unplug the seat occupancy sensor connector. (Under the front passenger seat, at the rear.)
3. Connect our emulator.
4. Start the car.

In a few cases, the airbag fault remains stored in the control unit and must be cleared with a diagnostic tool (this usually happens if you have driven for a long time with the fault light on).

CANCEL THE BMW 1 SERIES SEAT OCCUPANCY SENSOR FAULT

Instructions to override the passenger seatbelt fault:

1. Remove the key from the ignition.
2. Locate the yellow connector (under the front passenger seat). The shape of the connector may vary depending on the vehicle's year, but the color is always yellow.
3. Find the red and black wires in the connector; they are always next to each other.
4. Using a flathead screwdriver, disconnect the original red wire and connect the red pin of the emulator.
5. Using a flathead screwdriver, disconnect the original black wire and connect the black pin of the emulator.
6. Leave the original wires disconnected.
7. Start the car.

BMW E88 E87 E81 E82 SEAT BELT SENSOR EMULATOR