TE-OCUX EMULATOR MAT INSTALLATION

TO SEE THE SEAT OCCUPANCY SENSOR EMULATOR, CLICK HERE

1. Remove the key from the ignition

2. Locate the seat occupancy sensor plug and disconnect it. The plug is located under the passenger seat, depending on the year and model the type of plug may vary, but it always has three cables: red, brown, and white.

In the images below you can see some examples of plugs

3. Connect our emulator, in the same order. The red cable of the emulator with the red cable of the vehicle, the brown cable of the emulator with the brown cable of the vehicle, and the white cable of the emulator with the white cable of the vehicle.

4. Start the car.

In a few cases, the fault remains stored in the control unit and must be cleared using a diagnostic machine (this usually happens if you have driven for a long time with the fault light on)

PASSENGER SEAT BELT EMULATOR INSTALLATION

1. Remove the key from the ignition

2. Locate the yellow connector (under the passenger seat). The shape of the connector may vary depending on the year of the vehicle, but the color is always yellow.

3. Locate the red and black wires in the connector

4. Disconnect the original red wire and connect the red pin of the emulator.

5. Disconnect the original black wire and connect the black pin of the emulator.

6. Leave the original wires loose

7. Start the car