TO VIEW THE BMW SRS SEAT OCCUPANCY SENSOR/AIRBAG MAT EMULATOR UP TO YEAR 2005 CLICK HERE

Installation:
1. Remove the key from the ignition (ideally, disconnect the battery).
2. Locate the sensor under the front passenger seat at the rear and remove the original connector (as shown in the picture below).
3. Connect our emulator.

Solved.

NOTE! If you have driven for a long time with the fault light on, sometimes the fault does not clear immediately.

Solution: Clear the fault with a diagnostic tool. In some cases, driving about 40km is enough for the fault to clear on its own.

Warning: Do not carry babies in child seats in the front seat because in the event of an accident, the airbag will always deploy; it cannot be disconnected. This is a temporary solution, we always recommend replacing defective components with approved parts from the vehicle manufacturer.

316 ci 316 g 316 i 316 ti 318 ci 318 d 318 i 318 is 318 td 318 tds 318 ti 320 cd 320 ci 320 d 320 i 320 td 323 ci 323 i 323 ti 325 ci 325 i 325 is 325 td 325 tds 325 ti 325 xi 328 ci 328 i 330 cd 330 ci 330 d 330 i 330 xd 330 xi 518 g 518 i 520 d 520 i 523 i 524 td 525 d 525 i 525 ix 525 td 525 tds 525 xi 528 i 530 d 530 i 530 xd 530 xi 535 d 535 i 540 i 540 iP 545 i 550 i 630 i 645 ci 650 i 725 tds 728 i 728 il 730 d 730 i 730 il 730 ld 730 li 735 i 735 il 735 li 740 d 740 i 740 il 740 ilP 740 li 745 d 745 i 745 li 745 lis 750 i 750 il 750 ilP 750 ils 750 li 760 i 760 li 760 lis 840 ci 840 i 850 ci 850 csi Alpina B7 l7 hydrogen 7 m3 m3 csl m5 m6 x3 2.0d 3 2.0i x3 2.5i 3 3.0d x3 3.0i x5 3.0d x5 3.0ix 5 4.4i x5 4.6es x5 4.8is z3 1.8 z3 1.9 z3 2.0 z3 2.2i z3 2.5 z3 2.5i z3 2.8 z3 3.0